Electrical and Electronics

This paper presents a photovoltaic array (PVA) simulation model to be used in Matlab-Simulink GUI environment. The model is developed using basic circuit equations of the photovoltaic (PV) solar cells including the effects of temperature changes and solar irradiation. This PVA model is used with boost converter to analyze its output and usage for various constant DC operations efficiently. Further an applications of solar panel of low output voltage is shown in which the panel is simulated with boost converter and then its output is given to an SVPWM fed inverter which provides 3 phase AC supply for 3 phase induction motor, which is feeding half of the industrial world. The advantage of using PID controller with closed loop converters is also shown in this paper, which provides constant DC. The simulation of closed loop converter with solar panel is done and the results are presented

MIMO techniques increases the spectral efficiency of the transmission and increasing capacity by using Spatial Multiplexing and Precoding. MIMO Spatial Multiplexing is the simultaneous use of the same frequencies to transmit independent data streams. Precoding (mixing) of the two streams is used to optimize the transmission into the channel so that the receiver has the best chance of recovering the original data streams. Several nonlinear precoding methods including dirty paper coding is used to achieve the capacity region for MIMO. In this paper capacity of the MIMO system and sum rate comparison is analyzed by suggesting a modified precoding technique and a round robin user scheduling algorithm.

An innovative concept of International Mobile Telecommunications – Advanced (IMT-Advanced) which is specified by the International Telecommunications Union – Radio Communication Sector (ITU-R), aims to perform a peak data rate of up to 1 Gbps for low mobility and 100 Mbps for high mobility. A study item on Long Term Evolution (LTE)-Advanced has been commenced to meet the above need by the 3rd Generation Partnership Project (3GPP), that supports the transmission over a much wider bandwidth than the LTE systems. The techniques for efficient resource allocation for LTE-Advanced systems with aggregation of multiple Component Carriers (CC) are deeply analyzed in this paper. Bandwidth based resource allocation using carrier load balancing methods like Round-robin, Mobile Hashing and Walsh code methods, have been used and their performance analysis is done in terms of the throughput and coverage. It proposes a cross component carrier packet scheduling algorithm for an effective resource allocation among the users with aggregation of component carrier in comparison with the independent packet scheduling per CC. To study the multi carrier system, Long Term Evolution (LTE)-Advanced users and LTE Rel’8 users are selected. The various carrier load balancing methods are compared based on independent and cross CC packet scheduling and then coverage performance, cell throughput and user throughput are analyzed with the help of Full buffer and finite buffer transmission system.

This paper presents an optimum design technique of broadband two elements Yagi array antenna. The optimization parameter for the proposed antenna is the impedance bandwidth using appropriate dimensions of ground plane and in Yagi array, dipole is replace by patch, all element design in form patch. In this paper we observed effect with and without ground plane on impedance bandwidth. Appropriate Spacing is used between elements; all elements designed on scale of reflector, the proposed antenna can be used for C-Band application. For validation of proposed geometry IE3D Simulator is used.

The advent of wireless communications both inside and outside the home-office environment has led to an increased demand for effective encryption systems. The beauty of encryption technology comes out in more pronounced way when there is no absolute relation between cipher and original data and it is possible to rebuild the original image in much easier way. As chaotic systems are known to be more random and non-predictable, they can be made utilized in achieving the encryption. The transposition technology of encryption systems requires scrambleness behaviour in order to achieve the encryption of the data. This srambleness behaviour can be derived from the randomness property of chaos which can be better utilized in the techniques like transposition system. In wireless communication systems, bandwidth utilization is an important criterion. In order to use encryption system in wireless communication; key space plays an important role for the efficient utilization of the bandwidth. In this paper we present a chaos-based encryption algorithm for images. This algorithm is based on pixel scrambling where inthe randomness of the chaos is made utilized to scramble the position of the data. The position of the data is scrambled in the order of randomness of the elements obtained from the chaotic map and again rearranged back to their original position in decryption process.

With the rapid increase in number of women suffering from breast cancer, it’s early detection aids in fast and effective treatment. Mammography, which is currently the most popular method of breast screening has some limitation and microwave imaging offers an attractive alteration. Microwave imaging is attractive due to high contrast in dielectric properties between cancerous and non-cancerous tissue. The paper presents different type of feeding mechanism to the micro strip patch antenna used in microwave imaging and its comparison in an urge of getting an ultra-wide band of 3GHz within the frequency range of 3.2 GHz to 10.6 GHz. The antenna is Designed and simulated using Ansoft High Frequency Structure Simulator (HFSS)

This paper proposes Artificial Neural Network (ANN) model for the required DC-DC Converter Duty Cycle feeding Maximum Power to resistive load to be used for distributed generation (DG) applications. It proposes a PV module when coupled to a load through DC-DC Converter to supply this resistive load with the maximum power from the PV module. Some of DC-DC converters topologies are discussed in brief with concentration on Cúk and SEPIC Converters operations. The mechanism of load matching is described to give the required converter duty cycle at maximum power point (MPP). Relations in 3D figures are introduced for the most probable situations for irradiance and temperature with the corresponding PV voltage and current. Also, 3D figures for the desired duty cycle, output voltage and current of DC-DC converter to gain the maximum power to the resistive load at various irradiance and temperature values. Moreover; Artificial Neural Network (ANN) is used to implement a neural model with its algebraic function to take the probable system situations and outs the proposed converter duty cycle to give maximum power for the load. All the neural model are done with their hidden and output layers’ suitable neurons numbers and suitable performance goals depending on the 3D simulation figures shown in the paper.

All real systems that work with digitally represented data require error detecting codes because all real channels are noisy to some extent. The basic goal is to detect errors in data transmission over unreliable or noisy communication channels. Encoding and decoding techniques play a major role in digital communication as the received bit stream usually contains a number of errors. Cyclic Redundancy Codes (CRCs) provide a first line of defense against data corruption in many networks. The basic goal is to control errors in data transmission over unreliable or noisy communication channels. CRC code provides a simple, yet powerful, method for the detection of burst errors during digital data transmission and storage. In this paper simulation is shown and implementation of CRC-32 is done on TMS320VC5416.

Speech is an efficient mode of communication among human beings. The shape of glottal excitation may be speaker and language dependent. The objective of this paper is to investigate the quality of speech with respect to glottal excitation modification in Hindi and Dogri languages. For this, recordings of six speakers (3 males and 3 females) were carried out in Dogri and Hindi languages. Cardinal vowels (/a/, /i/, /u/) were extracted from recordings of each speaker. Investigations were carried out by modifying the glottal excitation component of speech and this modification is obtained by adding noise which is a random signal to the glottal excitation component. The analysis of the results showed that quality and intelligibity of speech changes with the modification of the glottal source component in such a manner that identity of a speaker is fully lost and the clarity is degraded though not fully lost. Further, it is perceived that with the modification clarity in male speakers is more degraded than female speakers.

This paper focuses on the design of multi-element micro strip patch antenna array applicable to WLAN/MIMO at 2.4 GHz. Obviously, the performance of multi-element antenna system depends critically on the proper design of the arrays. In this paper design and simulation of 4x1 micro strip patch array with software IE3D is discussed. The performance of array have been compared with that of a single element micro strip patch antenna .Also the effect of mutual coupling of array elements on its performance is discussed .To reduce surface wave propagation, implementation of EBG substrate is discussed.