Archives-J 

Scarcity of drinking water has been a major problem that most parts of this world are facing since years. Though many methods are there like electric water purifiers, they all are having very high initial and operational cost. Solar still is an exception for this. But, due to its lower yield, it is not yet commercialized. Most of those works to improve solar still efficiency and yield were given emphasize to improve the evaporation rate. But the condensation characteristics are also important. Condensing cover of the solar still and its inclination is one of such areas where detailed study is required. This research paper is intended to find the optimum inclination for the condensing cover for a solar still so as to get the maximum yield.

Biodiesel derived from nonedible feed stocks such as Mahua, Jatropha, Pongamia are detailed to be feasible choices for developing countries including India. This paper presents the results of investigation of performance and emissions characteristics of diesel engine using Mahua biodiesel. In this paper, the blends of varying proportions of Mahua biodiesel and diesel were prepared, analyzed and compared with the performance of diesel fuel, studied using a single cylinder diesel engine. The brake thermal efficiency, brake-specific fuel consumption, exhaust gas temperatures, Co, Hc, No, and smoke emissions was analyzed. The tests showed decrease in the brake thermal efficiencies (BTE) of the engine as the amount of Mahua biodiesel in the blend increased. The maximum percentage of reduction in BTE is 14.3% was observed for B-100 at full load. The exhaust gas temperature with the blends decreased as the proportion of Mahua increases in the blend. The smoke, Co, and No emissions of the engine were increased with the blends at all loads. However, Hc emissions of Mahua biodiesels were less than that of diesel.

Objective: The objective is to compare the sugarcane performance under contour -zonary cultivation techniques with the one under traditional cultivation techniques. Method: Sugarcanes of both Qiantang 4 and Qiantang 5 were planted with different techniques. When they reached technical maturity, the samples of their roots, leaves, stems, number of ratoon cane buds etc. were collected, measured and compared to find out the differences of the yield and quality of the sugarcanes cultivated with different techniques. Result: It is found that sugarcanes under the cultivation with contour -zonary techniques had following characters that were fresh root weight increasing by 92.81-117.57%, functional leaf number increasing by 10.11-14.68%, cane stem production increasing by 16.65-17.57%, cane sucrose contents increasing by 4.05-4.07% and ratoon number increasing by 62.81-65.10%. Conclusion: Sugarcanes cultivated with contour -zonary cultivation techniques perform better than the ones cultivated with traditional cultivation techniques in both their yield and their qualities.

Physical exercise provide immense help in assisting an individual to seek his all round growth and development in all the personal dimensions including the union of his self with the greater soul. Physical exercise is based on philosophy that is practical and for our day to day living. Physical exercise produces desirable physiological changes and has sound scientific basis. Physical exercise is the only technique through which the body of any human being can be healthy without any trainer, equipment and medicine. Thus, my purpose of this paper makes an attempt to analyse the role and importance of physical exercise in modern times of 21st Century as well as its effect on human being in this contemporary times. Physical exercise influences cognitive emotional, learning and neurophysiological domains both directly and indirectly, thereby rendering it as essential that this non-invasive, nonpharmacological intervention ought to form a part of children’s and adolescents long-term health programs. Several manifestation of physical exercise providing health benefits for children and adolescents are evident in healthy and functional muscles and bones, increased strength and endurance, angiogenesis and neurogenesis, the reduces risk for chronic disease such as overweight and diabetes, improve self-esteem and psychological well-being and finally higher levels of subjective and psychological well-being as well as reduces stress, anxiety and depression.

Coating formulations were developed with diluent or modifiers that remained incorporated as a minority discontinuous phase. Epoxy resins were formed from a DGEBA (diglycidyl ether of bisphenol A), prepolymer (Epikote 828) and MXDA, (m-Xylylenediamine). Butyl laurate (BL) and clay (montmorillonite) were used as the modifier and the filler, respectively. The epoxy network forming systems were prepared by mixing the DGEBA with BL and/or clay and degassed, followed by addition of the MXDA and further degassing. Polymerisation kinetics during epoxy network formations were obtained using Differential Scanning Calorimetry (DSC) on samples of quenched reaction mixtures pre-reacted isothermally at 60 oC at 5 min intervals up to 1 h. The results showed a step-wise increase in Tg and conversion with time. The exothermic process in the clay-filled resins was controlled by the catalytic activity of the clay surface with the resin system.

The District Cooch Behar endeavours a number of freshwater bodies both of lentic and lotic types having zooplankton communities. A total of sixteen taxa of zooplankton were recorded from the Panishala Beel (one lentic system) encompassing three rotifera, five copepoda, one ostracoda and seven cladocera. On the other hand, a total of thirteen taxa of zooplankton were recorded from the River Ghargharia (one lotic system) that includes five copepoda, one ostracoda, one rotifera and six cladocera. Both the water bodies contains four zooplankton groups and show same kind of group diversity in respect of their zooplankton group. Both the water bodies were dominated by Cyclops sp. most probably due to organic pollution and abundant nutrients.

Desertification is considered as an important problem facing arid and semi-arid regions, as Iran. These processes are resulted either from human activities or adverse natural conditions. However, the combination of both is often applicable. The aim of this study is the identification of areas sensitive to desertification in the southeastern coast of Iran. In this study we used from IMDPA model for quantitative of this problem and we used from GIS for mapping of desertification. Three main benchmarks of desertification, including: soil, wind erosion and climate were considered. The results show that the weight of soil is 1.7 that it is the most effective benchmark in region. On the other hand with analysis of indicators we know that the most important is annual precipitation. After obtain each weigh of benchmarks we understand that the weight of desertification intensity (DS) in region is 1.61 and located in very high class. We know more that 1321.74 (Ha) is in medium class and 2639.30(Ha) of area is in very high class. After soli benchmark, wind erosion with 1.64 value and climate with 1.51 value are effective in desertification.

In this study, a hydrometallurgical treatment for valuable metals recovery from rinsing water of electroplating industries is reported. This water contains high contents of Copper, Nickel, Lead, Zinc and Chromium ions. Copper is recovered by leaching in hydrochloric acid solution. The effects of acid concentration, temperature and treatment time were investigated. Lead and Nickel are removed by adsorption onto activated carbon from artificial binary-component aqueous solutions. The effects of pH, time, temperature, and amount of adsorbent were investigated. Maximum Lead adsorption was obtained at pH 5.5-6 and 80?C for 30 min., while for Nickel at pH 7 and room temperature for 60 min.

A regional geoelectrical study was embarked upon covering some major towns within the Niger Delta and Anambra basin. Some of the towns include; Owerri, Umuahia, Ohafia, Aba, Umuosu, Ngwa, Mbaise, Okigwe, Lekwesi, etc. About 100 Vertical Electrical Sounding points were established along two long profiles running perpendicularly to each other at North-South and East-West directions covering a distance of about 110km in each traverse. The maximum electrode spread was 500metres, AB/2. The schlumberger array was adopted on the field. The ABEM Terrameter SAS 4000 was used for the data acquisition. The purpose of the study is to examine the variability in lithological units both vertically and horizontally from the North to South and East to West along these profiles because there have been reported cases about land degradation like; gully erosion, landslide, minor subsidence, road failure, etc within the study area. The field data were processed with computer softwares. Iso-resistivity values at AB/2 equals 1m, 4m, 8m, 15m, 50m, 150m, 250m and 350m at surface electrode spacings were plotted and processed for each VES point in order to reveal the variation in resistivity with depth and variability changes in lithological units with depth. This procedure was repeated for all the VES stations on the East-West profile and North-South profile. Results show that the top soil contour has resistivities between 200?m and 9000?m while at AB/2 = 4m, resistivities are 500 - 1000?m (Aba), 1000 - 5000?m (Owerri), 2000 - 2500?m (Afikpo). Results were also obtained for AB/2 = 8m, 15m, 50m up to 250m. These resistivity values were interpreted as clay, shale, sand, etc, accordingly. From the correlation of the VES points, other geologic structures like faults, boundaries, flood plains, landsides are identified. Other environmental implications are highlighted.

The project named ‘RFID Based E-Document Verification Using Cloud’ proposes to make the E-Document Verification the new technology to reduce the human efforts for getting the documents from certain institutes and even from Government offices. It provides an easy access to the document generation even if the document is lost or misplaced. Radio Frequency Identification is the hardware concept to provide small RFID tags to the user with the electromagnetic waves and produce the signals to it and then access the data. In this project we have implemented the concept of Networking using java and the web application. The project aims at making the document verification and accessing very easy and saving a lot of time and energy and commotion among users.