Electrical and Electronics

In this work the speech disorder due to damaged Vocal Folds is discussed. The basics of the disorder are described here. The speech parameters are identified which characterize the disorder and correction system is designed to improve the speech quality. The speech signal samples of people of age between five to eighty years are considered for the present study. These speech signals are digitized and enhanced and analyzed for the Jitter, Shimmer, HNR, Pitch variations Tx graphs , Normalized Percentile fo characteristics and % Close Quotient EGG graphs using MATLAB, PRAAT, SFS and EXCEL platforms

This paper presents the model which is developed for single and coupled microstripline structure for both the even and odd-mode of propagation of waves. Most important and common models are: Conformal transformation model, coupled analysis model, hybrid analysis model, numerical analysis by relaxation model, even and odd-mode models, which is the outcome of the coupled line model. H.A. Wheeler derived the characteristic impedance and propagation parameters. Numerical methods are adopted by Stenelhalfer and Sylvester based on pure TEM-mode, Quasi-TEM mode and Non-TEM mode

Doubly fed induction generator (DFIG) based wind turbines have arisen as the leading technologies in wind power market as they offer a variable-speed, economically viable and efficient alternative to the fossil fuel. The present paper comprises of a wind energy conversion system which is simulated using two level pulse width modulation (PWM) converter as well as three level (PWM) converter and their performance under normal and fault conditions are compared. It is observed that multi-level inverters generate purer sinusoidal voltage with reduced total harmonic distortion thus bringing an improvement in the quality of generated power.

A new architecture of multiplier-and-accumulator (MAC) for high-speed arithmetic. In this by combining multiplication with accumulation and devising a hybrid type of carry save adder (CSA), the performance was improved. The CSA tree uses 1’s-complement- based radix-2. Modified Booth’s algorithm (MBA) and has the modified array for the sign extension in order to increase the bit density of the operands. The CSA propagates the carries to the least significant bits of the partial products and generates the least significant bits in advance to decrease the number of the input bits of the final adder. The MAC accumulates the intermediate results in the type of sum and carry bits instead of the output of the final adder, which made it possible to optimize the pipeline scheme to improve the performance.

This paper presents a novel approach to the design and implementation of CPLD (Complex Programmable Logic Devices) based DAS (Data Acquisition System) for varies application. This technique performs the acquisition of physical signal, conversion of analog signal to digital signal and storing of the information. The core heart of the proposed system is CPLD, which allows individual modules on a chip to work independently from each other which is configured and programmed to acquire real time data. The data for the process is acquired using suitable temperature and gas sensors. Signal conditioners are designed for each sensor and are tested in real time. The ADC0808 (analog to digital converter) is adopted for this system, which is a high speed monolithic CMOS device with an 8-bit, 8-channel analog-to-digital converter using successive approximation as the conversion technique. Cool Runner-II CPLD by Xilinx is used as the main controller from which all modules are implemented in VHDL using Xilinx ISE Design Suite9.2 and simulated using Isim.

In a deregulated electricity industry, congestion is most likely to occur and FACTS devices have been proven to be very effective in mitigating this challenge. In this paper a sensitivity based analysis is used to determine the optimal place to locate series FACTS devices, the device used for the investigation is Thyristor Controlled Series Capacitor (TCSC). This approach was tested on the South East Nigerian 11 – bus network. The Power System Analysis Toolbox (PSAT), was used for the simulation of the system. The load flow results obtained showed the effectiveness of the method.

Resonance disorders are observed in patients with a history of cleft palate or cleft lips. Evaluation of speech pathology helps for the proper treatment of a resonance disorder. The speech parameters are identified here which characterizes the disorder and correction system is designed to improve the speech quality. The speech signal samples of people of age between five to eighty years are considered for the present study. These speech signals are digitized and enhanced and analyzed for the Jitter, Shimmer, HNR, Pitch variations Tx graphs , Normalized Percentile fo characteristics and % Close Quotient EGG graphs using MATLAB, PRAAT, SFS and EXCEL platforms.

A Broadband multilayer antenna for C-Band applications is presented in this paper. The proposed antenna is composed of a FR-4 and air gap Dielectric material, two square slots, two L-Slot, and a Radom. By introducing the two parts, the impedance bandwidth of the antenna can be significantly enhanced. Analysis done with and without ground plane. Simulation results show that the proposed antenna can operate from 3.2GHz to 4.8 GHz with low VSWRs ? 2. Stable antenna gain (dB) is also achieved over the entire operating frequency band. Furthermore, the size of the proposed antenna is very compact, which is only at the centre of the operating frequency band.

The concept of smart grid is a promising issue in the field of energy management. There are lots of researches going on different aspect of this system. One of the major topics that is involved in this concept is the communication constraints. In this paper we have analyzed few aspects of smart grid system. The main focus is on the communication technologies and their threats along with solutions. We have considered different literatures to investigate the overall concept of smart grid and prepared a review on the topic.

This paper presents comparative study of Hybrid Multilevel Inverter in continuation to previous paper. Different distinct topologies of multilevel inverters for power circuits used in Hybrid Multilevel Inverter are discussed. The comparison is done with respect to different performance index like switching devices, power applications and modulation techniques used. Different topologies are discussed and reviewed in brief.